Epson TX420W Waste Ink Counter Reset
If your Epson TX420W suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.
The Epson TX420W tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.
Understanding the Epson TX420W Waste Ink Counter
With Wic Reset Connect, you can reset the Epson TX420W waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.
How the Error Appears
- Printer refuses to print even with ink available
- Epson Status Monitor shows maintenance warning
- Blinking lights and blocked jobs
- Device is locked until reset is performed
Step-by-Step: Epson TX420W Waste Counter Reset
- Schritt 1: Prepare a Windows PC + USB cable and connect Epson TX420W directly. Keep Internet enabled for validation.
- Schritt 2: Run Wic Reset Connect as Administrator and confirm Epson TX420W is detected.
- Schritt 3: Paste the reset key, click Reset, and after completion power-cycle Epson TX420W.
Most Epson TX420W waste counter resets finish in ~1–2 minutes.
What You Need
- USB connection required (Wi-Fi reset not supported)
- Stable Internet connection during reset
- Windows 7/8/10/11 PC
- Valid Wic Reset Connect reset key
Common Fixes
- Restart printer and PC, then try again.
- Run the app as Administrator.
- Temporarily disable VPN/proxy if validation fails.
- Use a direct USB connection (avoid hubs).
- Try another USB cable (some cables are charge-only).
Frequently Asked Questions
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
How long does it take?
Usually about 1–2 minutes.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
Guide prepared for Epson TX420W – Waste Ink Counter Reset using Wic Reset Connect.