Epson XP-240 Waste Ink Counter Reset

When the Epson XP-240 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson XP-240 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Understanding the Epson XP-240 Waste Ink Counter

Most Epson XP-240 waste ink counter locks are solved by a software counter reset. Wic Reset Connect giver en ligetil procedure.

Epson XP-240 Ink Pad Counter Reset – Quick Steps

1. Trin 1: Connect Epson XP-240 to a Windows computer with a stable Internet connection using a USB cable.
2. Trin 2: Start Wic Reset Connect in Administrator mode and wait until Epson XP-240 appears in the device list.
3. Trin 3: Use the key to reset the counter, wait for completion, then restart Epson XP-240 to finalize.

Most Epson XP-240 waste counter resets finish in ~1–2 minutes.

Før du begynder

• USB-forbindelse påkrævet (Wi-Fi-nulstilling understøttes ikke)
• Stabil internetforbindelse under nulstilling
• Gyldig Wic-nulstilling Tilslut nulstillingsnøgle
• Windows 7/8/10/11 PC

Hvis printeren ikke registreres

• Genstart printeren og pc'en, og prøv igen.
• Deaktiver midlertidigt VPN/proxy, hvis valideringen mislykkes.
• Kør appen som administrator.
• Luk Epson Status Monitor eller andre printerværktøjer.
• Prøv et andet USB-kabel (nogle kabler er kun til opladning).

OFTE STILLEDE SPØRGSMÅL