Epson TX650 Waste Ink Counter Reset

When the Epson TX650 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson TX650 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why the Epson TX650 Stops Printing (Waste Counter Limit)

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson TX650 waste counter reset in minutes.

Typical Signs

• Printer refuses to print even with ink available
• Epson Status Monitor shows maintenance warning
• Blinking lights and blocked jobs
• Device is locked until reset is performed

Three Steps to Restore Epson TX650 Printing

1. Trin 1: Use a Windows PC (7–11) with Internet access. Connect Epson TX650 via USB (Wi-Fi reset is not supported).
2. Trin 2: Run Wic Reset Connect as Administrator and confirm Epson TX650 is detected.
3. Trin 3: Use the key to reset the counter, wait for completion, then restart Epson TX650 to finalize.

Most Epson TX650 waste counter resets finish in ~1–2 minutes.

System Requirements

• USB connection required (Wi-Fi reset not supported)
• Valid Wic Reset Connect reset key
• Windows 7/8/10/11 PC
• Stable Internet connection during reset

Troubleshooting

• Try another USB cable (some cables are charge-only).
• Close Epson Status Monitor or other printer utilities.
• Use a direct USB connection (avoid hubs).
• Restart printer and PC, then try again.
• Temporarily disable VPN/proxy if validation fails.

FAQ