Epson T50 Waste Ink Counter Reset

If your Epson T50 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson T50 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why Does the Epson T50 Show ‘Service Required’?

Med Wic Reset Connect, you can reset the Epson T50 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Reset Epson T50 Waste Ink Counter in 3 Steps

1. Trin 1: Use a Windows PC (7–11) with Internet access. Connect Epson T50 via USB (Wi-Fi reset is not supported).
2. Trin 2: Start Wic Reset Connect in Administrator mode and wait until Epson T50 appears in the device list.
3. Trin 3: Use the key to reset the counter, wait for completion, then restart Epson T50 to finalize.

Most Epson T50 waste counter resets finish in ~1–2 minutes.

Hvad du har brug for

• USB-forbindelse påkrævet (Wi-Fi-nulstilling understøttes ikke)
• Windows 7/8/10/11 PC
• Stabil internetforbindelse under nulstilling
• Gyldig Wic-nulstilling Tilslut nulstillingsnøgle

Hvis printeren ikke registreres

• Luk Epson Status Monitor eller andre printerværktøjer.
• Kør appen som administrator.
• Deaktiver midlertidigt VPN/proxy, hvis valideringen mislykkes.
• Genstart printeren og pc'en, og prøv igen.
• Prøv et andet USB-kabel (nogle kabler er kun til opladning).

OFTE STILLEDE SPØRGSMÅL