Epson SX100 Waste Ink Counter Reset

When the Epson SX100 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson SX100 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Understanding the Epson SX100 Waste Ink Counter

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson SX100 waste counter reset in minutes.

Reset Epson SX100 Waste Ink Counter in 3 Steps

1. Trin 1: Prepare a Windows PC + USB cable and connect Epson SX100 directly. Keep Internet enabled for validation.
2. Trin 2: Run Wic Reset Connect as Administrator and confirm Epson SX100 is detected.
3. Trin 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson SX100.

Most Epson SX100 waste counter resets finish in ~1–2 minutes.