Model-specific reset guide
Canon TS3377S Ink Absorber Full Reset
Canon TS3377S may block print jobs after recording enough cleaning and maintenance cycles. Use the sequence below to enter service mode and reset the stored value.
What the Canon TS3377S service message means
An absorber message concerns both software and maintenance. The counter can be reset, while heavily saturated pads may still need cleaning or replacement.
Wic Reset Connect is designed to reset the compatible counter in Canon TS3377S. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon TS3377S
- Turn the printer off.
- Tryk og hold nede Stop/Reset.
- Mens du holder Stop/Reset, skal du trykke og holde Kraft.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 gange.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon TS3377S
Check cartridges, close Canon utilities and connect the printer directly to Windows before beginning the reset.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon TS3377S to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon TS3377S is not detected
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
- Connect Canon TS3377S directly to the computer and try another data-capable USB cable or port.
Canon TS3377S reset FAQ
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Restore Canon TS3377S
Follow the verified steps for Canon TS3377S, then restart the printer and return to normal operation.