Model-specific reset guide
Canon MG6300 Ink Absorber Full Reset
Canon MG6300 may block print jobs after recording enough cleaning and maintenance cycles. Use the sequence below to enter service mode and reset the stored value.
The waste ink counter inside Canon MG6300
Canon MG6300 uses a stored counter as a maintenance safeguard. Reaching the threshold can produce an Ink Absorber Full, Service Required or related support-code message.
Wic Reset Connect is designed to reset the compatible counter in Canon MG6300. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon MG6300
- Turn the printer off.
- Tryk og hold nede Stop/Reset.
- Mens du holder Stop/Reset, skal du trykke og holde Kraft.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 6 gange.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon MG6300
Check cartridges, close Canon utilities and connect the printer directly to Windows before beginning the reset.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon MG6300 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon MG6300 is not detected
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- Connect Canon MG6300 directly to the computer and try another data-capable USB cable or port.
Canon MG6300 reset FAQ
Hvor mange gange skal jeg trykke på Stop/Reset?
For Canon MG6300, use 6 Stop/Reset presses in the sequence shown on this page.
Does Canon MG6300 require service mode?
Yes. The printer must expose its maintenance interface before the counter can be reset with Wic Reset Connect.
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Restore Canon MG6300
Complete the Canon MG6300 absorber counter reset in a few carefully prepared steps.