Model-specific reset guide
Canon GM4070 Ink Absorber Full Reset
When Canon GM4070 reports that the ink absorber is full, turning it off and on will not normally remove the lock. The printer must be prepared correctly and its counter reset.
What the Canon GM4070 service message means
The lock is based on accumulated maintenance activity. Resetting Canon GM4070 changes the counter value but does not remove ink already held in the absorber material.
Wic Reset Connect is designed to reset the compatible counter in Canon GM4070. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon GM4070
- Turn the printer off.
- Tryk og hold nede Stop/Reset.
- Mens du holder Stop/Reset, skal du trykke og holde Kraft.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 gange.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon GM4070
Work through the sequence without rushing. Incorrect button timing or a blinking power light means the printer is not ready for the counter reset.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon GM4070 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon GM4070 is not detected
- Run Wic Reset Connect as Administrator and keep internet access active for key validation.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- If Windows does not detect a service-mode device, restart the printer normally, wait 10 seconds and repeat the preparation.
Canon GM4070 reset FAQ
Hvor mange gange skal jeg trykke på Stop/Reset?
For Canon GM4070, use 5 Stop/Reset presses in the sequence shown on this page.
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Does the reset clean the ink absorber?
No. It resets the stored counter. Inspect, clean or replace the absorber pads when their physical condition requires maintenance.
Restore Canon GM4070
Follow the verified steps for Canon GM4070, then restart the printer and return to normal operation.