Model-specific reset guide
Canon G5092 Ink Absorber Full Reset
When Canon G5092 reports that the ink absorber is full, turning it off and on will not normally remove the lock. The printer must be prepared correctly and its counter reset.
What the Canon G5092 service message means
An absorber message concerns both software and maintenance. The counter can be reset, while heavily saturated pads may still need cleaning or replacement.
Wic Reset Connect is designed to reset the compatible counter in Canon G5092. The physical waste ink system should still be inspected and maintained when necessary.
How to enter service mode on Canon G5092
- Turn the printer off.
- Tryk og hold nede Stop/Reset.
- Mens du holder Stop/Reset, skal du trykke og holde Kraft.
- Release Stop/Reset but keep holding Power.
- Press and release Stop/Reset 5 gange.
- Wait briefly, then release Power. The power indicator should remain steadily lit.
Reset the counter in Canon G5092
Check cartridges, close Canon utilities and connect the printer directly to Windows before beginning the reset.
-
Prepare the printer
Resolve other errors, confirm a steady power light and enter service mode using the sequence above.
-
Connect directly by USB
Connect Canon G5092 to a Windows 7, 8, 10 or 11 computer without Wi-Fi or a USB hub.
-
Start Wic Reset Connect
Run the program as Administrator and wait until the Canon service-mode device is detected.
-
Enter the key and reset
Enter the purchased key, select Reset and keep the printer connected until confirmation appears.
If Canon G5092 is not detected
- Close Canon maintenance utilities and clear paused print jobs before opening Wic Reset Connect.
- Connect Canon G5092 directly to the computer and try another data-capable USB cable or port.
- If the power light blinks, resolve the displayed cartridge, paper or mechanical error before trying service mode again.
- Repeat the button sequence at a steady pace; releasing Power too early is a common reason service mode fails.
Canon G5092 reset FAQ
Can I perform the reset over Wi-Fi?
No. Use a direct USB connection between the printer and a Windows computer.
Hvor mange gange skal jeg trykke på Stop/Reset?
For Canon G5092, use 5 Stop/Reset presses in the sequence shown on this page.
What if my reset key was used during a failed attempt?
Correct the cause first, then use the new-key generator or contact support for assistance.
Restore Canon G5092
Complete the Canon G5092 absorber counter reset in a few carefully prepared steps.