Epson ET-M1108 Waste Ink Counter Reset

The Epson ET-M1108 is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.

A waste ink counter in the Epson ET-M1108 accumulates after cleaning operations. Once it reaches a limit, printing is stopped to prevent overflow.

Why Does the Epson ET-M1108 Show ‘Service Required’?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson ET-M1108 waste counter reset in minutes.

Typical Signs

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Reset Epson ET-M1108 Waste Ink Counter in 3 Steps

1. Krok 1: Use a Windows PC (7–11) with Internet access. Connect Epson ET-M1108 via USB (Wi-Fi reset is not supported).
2. Krok 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson ET-M1108.
3. Krok 3: Paste the reset key, click Reset, and after completion power-cycle Epson ET-M1108.

Most Epson ET-M1108 waste counter resets finish in ~1–2 minutes.

System Requirements

• Stable Internet connection during reset
• USB connection required (Wi-Fi reset not supported)
• Valid Wic Reset Connect reset key
• Windows 7/8/10/11 PC

Troubleshooting

• Close Epson Status Monitor or other printer utilities.
• Restart printer and PC, then try again.
• Use a direct USB connection (avoid hubs).
• Run the app as Administrator.
• Try another USB cable (some cables are charge-only).

FAQ