Reset Epson ET-2712 Waste Ink Counter in Minutes

Epson ET-2712 Waste Ink Counter Reset

When the Epson ET-2712 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

A waste ink counter in the Epson ET-2712 accumulates after cleaning operations. Once it reaches a limit, printing is stopped to prevent overflow.

Understanding the Epson ET-2712 Waste Ink Counter

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson ET-2712 waste counter reset in minutes.

Typical Signs

  • Printer refuses to print even with ink available
  • Epson Status Monitor shows maintenance warning
  • Blinking lights and blocked jobs
  • Device is locked until reset is performed

Step-by-Step: Epson ET-2712 Waste Counter Reset

  1. Krok 1: Prepare a Windows PC + USB cable and connect Epson ET-2712 directly. Keep Internet enabled for validation.
  2. Krok 2: Start Wic Reset Connect in Administrator mode and wait until Epson ET-2712 appears in the device list.
  3. Krok 3: Use the key to reset the counter, wait for completion, then restart Epson ET-2712 to finalize.
Buy Reset Key ⬇️ Download Wic Reset Connect Instrukce

Most Epson ET-2712 waste counter resets finish in ~1–2 minutes.

Before You Begin

  • Valid Wic Reset Connect reset key
  • Stable Internet connection during reset
  • Windows 7/8/10/11 PC
  • USB connection required (Wi-Fi reset not supported)

Frequently Asked Questions

Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
How long does it take?
Usually about 1–2 minutes.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.

Guide prepared for Epson ET-2712 – Waste Ink Counter Reset using Wic Reset Connect.

Nákupní vozík