Epson XP-452 Waste Ink Counter Reset

When the Epson XP-452 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

A waste ink counter in the Epson XP-452 accumulates after cleaning operations. Once it reaches a limit, printing is stopped to prevent overflow.

Why the Epson XP-452 Stops Printing (Waste Counter Limit)

Most Epson XP-452 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Typical Signs

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Epson XP-452 Ink Pad Counter Reset – Quick Steps

1. Стъпка 1: Prepare a Windows PC + USB cable and connect Epson XP-452 directly. Keep Internet enabled for validation.
2. Стъпка 2: Start Wic Reset Connect in Administrator mode and wait until Epson XP-452 appears in the device list.
3. Стъпка 3: Use the key to reset the counter, wait for completion, then restart Epson XP-452 to finalize.

Most Epson XP-452 waste counter resets finish in ~1–2 minutes.

What You Need

• Windows 7/8/10/11 PC
• Valid Wic Reset Connect reset key
• USB connection required (Wi-Fi reset not supported)
• Stable Internet connection during reset

If the Printer Is Not Detected

• Try another USB cable (some cables are charge-only).
• Run the app as Administrator.
• Temporarily disable VPN/proxy if validation fails.
• Use a direct USB connection (avoid hubs).
• Restart printer and PC, then try again.

Frequently Asked Questions