Epson WorkForce 620 Ink Pad Counter Reset Guide

Epson WorkForce 620 Waste Ink Counter Reset

When the Epson WorkForce 620 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

A waste ink counter in the Epson WorkForce 620 accumulates after cleaning operations. Once it reaches a limit, printing is stopped to prevent overflow.

Why Does the Epson WorkForce 620 Show ‘Service Required’?

With Wic Reset Connect, you can reset the Epson WorkForce 620 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Typical Signs

  • ‘Service Required’ / service life message in driver or utility
  • Maintenance/support code (varies by model/driver)
  • Printing stops after cleaning cycles
  • Warning repeats after restarting the printer

Reset Epson WorkForce 620 Waste Ink Counter in 3 Steps

  1. Step 1: Prepare a Windows PC + USB cable and connect Epson WorkForce 620 directly. Keep Internet enabled for validation.
  2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson WorkForce 620 is detected.
  3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson WorkForce 620 to finalize.
Buy Reset Key ⬇️ Download Wic Reset Connect التعليمات

Most Epson WorkForce 620 waste counter resets finish in ~1–2 minutes.

What You Need

  • Valid Wic Reset Connect reset key
  • Windows 7/8/10/11 PC
  • Stable Internet connection during reset
  • USB connection required (Wi-Fi reset not supported)

FAQ

How long does it take?
Usually about 1–2 minutes.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.

Guide prepared for Epson WorkForce 620 – Waste Ink Counter Reset using Wic Reset Connect.

عربة التسوق