Epson L365 Waste Ink Counter Reset

The Epson L365 is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson L365 uses a software counter to estimate pad saturation and locks printing at a set threshold.

What Causes the Epson L365 Ink Pad Counter Warning?

Most Epson L365 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Typical Signs

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Reset Epson L365 Waste Ink Counter in 3 Steps

1. Step 1: Prepare a Windows PC + USB cable and connect Epson L365 directly. Keep Internet enabled for validation.
2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson L365 is detected.
3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson L365.

Most Epson L365 waste counter resets finish in ~1–2 minutes.

System Requirements

• USB connection required (Wi-Fi reset not supported)
• Windows 7/8/10/11 PC
• Stable Internet connection during reset
• Valid Wic Reset Connect reset key

Common Fixes

• Use a direct USB connection (avoid hubs).
• Try another USB cable (some cables are charge-only).
• Restart printer and PC, then try again.
• Close Epson Status Monitor or other printer utilities.
• Run the app as Administrator.

Frequently Asked Questions