Epson L3060 Waste Ink Counter Reset

When the Epson L3060 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson L3060 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Understanding the Epson L3060 Waste Ink Counter

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson L3060 waste counter reset in minutes.

Common Symptoms

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Epson L3060 Ink Pad Counter Reset – Quick Steps

1. Step 1: Prepare a Windows PC + USB cable and connect Epson L3060 directly. Keep Internet enabled for validation.
2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson L3060.
3. Step 3: Paste the reset key, click Reset, and after completion power-cycle Epson L3060.

Most Epson L3060 waste counter resets finish in ~1–2 minutes.

System Requirements

• USB connection required (Wi-Fi reset not supported)
• Stable Internet connection during reset
• Windows 7/8/10/11 PC
• Valid Wic Reset Connect reset key

Common Fixes

• Try another USB cable (some cables are charge-only).
• Temporarily disable VPN/proxy if validation fails.
• Run the app as Administrator.
• Close Epson Status Monitor or other printer utilities.
• Restart printer and PC, then try again.

FAQ