Epson XP-443 Waste Ink Counter Reset

When the Epson XP-443 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson XP-443 uses a software counter to estimate pad saturation and locks printing at a set threshold.

What Causes the Epson XP-443 Ink Pad Counter Warning?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson XP-443 waste counter reset in minutes.

Common Symptoms

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Step-by-Step: Epson XP-443 Waste Counter Reset

1. Step 1: Prepare a Windows PC + USB cable and connect Epson XP-443 directly. Keep Internet enabled for validation.
2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson XP-443 is detected.
3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson XP-443.

Most Epson XP-443 waste counter resets finish in ~1–2 minutes.

Before You Begin

• Windows 7/8/10/11 PC
• Valid Wic Reset Connect reset key
• Stable Internet connection during reset
• USB connection required (Wi-Fi reset not supported)

If the Printer Is Not Detected

• Temporarily disable VPN/proxy if validation fails.
• Run the app as Administrator.
• Close Epson Status Monitor or other printer utilities.
• Use a direct USB connection (avoid hubs).
• Restart printer and PC, then try again.

Frequently Asked Questions