Epson WF-2518 Waste Ink Counter Reset

When the Epson WF-2518 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

A waste ink counter in the Epson WF-2518 accumulates after cleaning operations. Once it reaches a limit, printing is stopped to prevent overflow.

Why the Epson WF-2518 Stops Printing (Waste Counter Limit)

With Wic Reset Connect, you can reset the Epson WF-2518 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Common Symptoms

• Printer refuses to print even with ink available
• Epson Status Monitor shows maintenance warning
• Blinking lights and blocked jobs
• Device is locked until reset is performed

Epson WF-2518 Ink Pad Counter Reset – Quick Steps

1. Adım 1: Prepare a Windows PC + USB cable and connect Epson WF-2518 directly. Keep Internet enabled for validation.
2. Adım 2: Run Wic Reset Connect as Administrator and confirm Epson WF-2518 is detected.
3. Adım 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson WF-2518.

Most Epson WF-2518 waste counter resets finish in ~1–2 minutes.

System Requirements

• Stable Internet connection during reset
• Windows 7/8/10/11 PC
• Valid Wic Reset Connect reset key
• USB connection required (Wi-Fi reset not supported)

If the Printer Is Not Detected

• Restart printer and PC, then try again.
• Run the app as Administrator.
• Close Epson Status Monitor or other printer utilities.
• Use a direct USB connection (avoid hubs).
• Temporarily disable VPN/proxy if validation fails.