Epson WF-2010 Ink Pad Counter Reset Guide

Epson WF-2010 Waste Ink Counter Reset

When the Epson WF-2010 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson WF-2010 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why Does the Epson WF-2010 Show ‘Service Required’?

With Wic Reset Connect, you can reset the Epson WF-2010 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Common Symptoms

Printer refuses to print even with ink available
Epson Status Monitor shows maintenance warning
Blinking lights and blocked jobs
Device is locked until reset is performed

Reset Epson WF-2010 Waste Ink Counter in 3 Steps

Adım 1: Prepare a Windows PC + USB cable and connect Epson WF-2010 directly. Keep Internet enabled for validation.
Adım 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson WF-2010.
Adım 3: Use the key to reset the counter, wait for completion, then restart Epson WF-2010 to finalize.

Buy Reset Key ⬇️ Download Wic Reset Connect Talimatlar

Most Epson WF-2010 waste counter resets finish in ~1–2 minutes.

Common Fixes

Use a direct USB connection (avoid hubs).
Temporarily disable VPN/proxy if validation fails.
Run the app as Administrator.
Restart printer and PC, then try again.
Close Epson Status Monitor or other printer utilities.

Frequently Asked Questions

What if reset doesn’t work?

Check USB cable/port, run as admin, and close other printer utilities.

Do I need a service center?

Typically not for a waste ink counter lock; a reset is usually sufficient.

Can I reset over Wi-Fi?

No. The reset requires a USB connection to a Windows PC.

How long does it take?

Usually about 1–2 minutes.

Guide prepared for Epson WF-2010 – Waste Ink Counter Reset using Wic Reset Connect.