Epson TX820FWD Waste Ink Counter Reset

When the Epson TX820FWD reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

A waste ink counter in the Epson TX820FWD accumulates after cleaning operations. Once it reaches a limit, printing is stopped to prevent overflow.

Why the Epson TX820FWD Stops Printing (Waste Counter Limit)

With Wic Reset Connect, you can reset the Epson TX820FWD waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Common Symptoms

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Reset Epson TX820FWD Waste Ink Counter in 3 Steps

1. Adım 1: Connect Epson TX820FWD to a Windows computer with a stable Internet connection using a USB cable.
2. Adım 2: Start Wic Reset Connect in Administrator mode and wait until Epson TX820FWD appears in the device list.
3. Adım 3: Paste the reset key, click Reset, and after completion power-cycle Epson TX820FWD.

Most Epson TX820FWD waste counter resets finish in ~1–2 minutes.

Before You Begin

• Stable Internet connection during reset
• Valid Wic Reset Connect reset key
• USB connection required (Wi-Fi reset not supported)
• Windows 7/8/10/11 PC

Troubleshooting

• Close Epson Status Monitor or other printer utilities.
• Run the app as Administrator.
• Use a direct USB connection (avoid hubs).
• Try another USB cable (some cables are charge-only).
• Temporarily disable VPN/proxy if validation fails.