Epson TX230 Waste Ink Counter Reset

When the Epson TX230 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson TX230 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

What Causes the Epson TX230 Ink Pad Counter Warning?

With Wic Reset Connect, you can reset the Epson TX230 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Common Symptoms

• Printer refuses to print even with ink available
• Epson Status Monitor shows maintenance warning
• Blinking lights and blocked jobs
• Device is locked until reset is performed

Epson TX230 Ink Pad Counter Reset – Quick Steps

1. Adım 1: Connect Epson TX230 to a Windows computer with a stable Internet connection using a USB cable.
2. Adım 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson TX230.
3. Adım 3: Use the key to reset the counter, wait for completion, then restart Epson TX230 to finalize.

Most Epson TX230 waste counter resets finish in ~1–2 minutes.

What You Need

• Valid Wic Reset Connect reset key
• Windows 7/8/10/11 PC
• USB connection required (Wi-Fi reset not supported)
• Stable Internet connection during reset

Common Fixes

• Use a direct USB connection (avoid hubs).
• Try another USB cable (some cables are charge-only).
• Temporarily disable VPN/proxy if validation fails.
• Run the app as Administrator.
• Close Epson Status Monitor or other printer utilities.

Frequently Asked Questions