Epson XP-220 Waste Ink Counter Reset
If your Epson XP-220 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.
A waste ink counter in the Epson XP-220 accumulates after cleaning operations. Once it reaches a limit, printing is stopped to prevent overflow.
What Causes the Epson XP-220 Ink Pad Counter Warning?
A service visit is often unnecessary. Wic Reset Connect allows a safe Epson XP-220 waste counter reset in minutes.
Typical Signs
- ‘Service Required’ / service life message in driver or utility
- Maintenance/support code (varies by model/driver)
- Printing stops after cleaning cycles
- Warning repeats after restarting the printer
Reset Epson XP-220 Waste Ink Counter in 3 Steps
- Step 1: Connect Epson XP-220 to a Windows computer with a stable Internet connection using a USB cable.
- Step 2: Run Wic Reset Connect as Administrator and confirm Epson XP-220 is detected.
- Step 3: Use the key to reset the counter, wait for completion, then restart Epson XP-220 to finalize.
Most Epson XP-220 waste counter resets finish in ~1–2 minutes.
System Requirements
- Valid Wic Reset Connect reset key
- USB connection required (Wi-Fi reset not supported)
- Windows 7/8/10/11 PC
- Stable Internet connection during reset
Troubleshooting
- Run the app as Administrator.
- Temporarily disable VPN/proxy if validation fails.
- Try another USB cable (some cables are charge-only).
- Close Epson Status Monitor or other printer utilities.
- Use a direct USB connection (avoid hubs).
FAQ
How long does it take?
Usually about 1–2 minutes.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
Guide prepared for Epson XP-220 – Waste Ink Counter Reset using Wic Reset Connect.