Epson WF-7525 Waste Ink Counter Reset

When the Epson WF-7525 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson WF-7525 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why Does the Epson WF-7525 Show ‘Service Required’?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson WF-7525 waste counter reset in minutes.

Typical Signs

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Epson WF-7525 Ink Pad Counter Reset – Quick Steps

1. 1. korak: Use a Windows PC (7–11) with Internet access. Connect Epson WF-7525 via USB (Wi-Fi reset is not supported).
2. 2. korak: Run Wic Reset Connect as Administrator and confirm Epson WF-7525 is detected.
3. 3. korak: Paste the reset key, click Reset, and after completion power-cycle Epson WF-7525.

Most Epson WF-7525 waste counter resets finish in ~1–2 minutes.

Before You Begin

• Valid Wic Reset Connect reset key
• Windows 7/8/10/11 PC
• USB connection required (Wi-Fi reset not supported)
• Stable Internet connection during reset

Common Fixes

• Run the app as Administrator.
• Close Epson Status Monitor or other printer utilities.
• Restart printer and PC, then try again.
• Try another USB cable (some cables are charge-only).
• Temporarily disable VPN/proxy if validation fails.

Frequently Asked Questions