Epson ET-1810 Waste Ink Counter Reset

Epson ET-1810 Waste Ink Counter Reset

The Epson ET-1810 is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.

The Epson ET-1810 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

What Causes the Epson ET-1810 Ink Pad Counter Warning?

With Wic Reset Connect, you can reset the Epson ET-1810 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Typical Signs

  • Printer refuses to print even with ink available
  • Epson Status Monitor shows maintenance warning
  • Blinking lights and blocked jobs
  • Device is locked until reset is performed

Epson ET-1810 Ink Pad Counter Reset – Quick Steps

  1. 1. korak: Connect Epson ET-1810 to a Windows computer with a stable Internet connection using a USB cable.
  2. 2. korak: Run Wic Reset Connect as Administrator and confirm Epson ET-1810 is detected.
  3. 3. korak: Use the key to reset the counter, wait for completion, then restart Epson ET-1810 to finalize.
Buy Reset Key ⬇️ Download Wic Reset Connect Navodila

Most Epson ET-1810 waste counter resets finish in ~1–2 minutes.

System Requirements

  • Stable Internet connection during reset
  • Windows 7/8/10/11 PC
  • USB connection required (Wi-Fi reset not supported)
  • Valid Wic Reset Connect reset key

FAQ

What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
How long does it take?
Usually about 1–2 minutes.

Guide prepared for Epson ET-1810 – Waste Ink Counter Reset using Wic Reset Connect.

Nakupovalna košarica