Fix Epson L485 Service Required – Waste Counter Reset

Epson L485 Waste Ink Counter Reset

The Epson L485 delivers reliable printing, but periodic maintenance routines can increase the waste ink counter and eventually trigger a ‘Service Required’ lock.

The Epson L485 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why the Epson L485 Stops Printing (Waste Counter Limit)

Most Epson L485 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Common Symptoms

  • ‘Service Required’ / service life message in driver or utility
  • Maintenance/support code (varies by model/driver)
  • Printing stops after cleaning cycles
  • Warning repeats after restarting the printer

Reset Epson L485 Waste Ink Counter in 3 Steps

  1. Step 1: Prepare a Windows PC + USB cable and connect Epson L485 directly. Keep Internet enabled for validation.
  2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson L485.
  3. Step 3: Paste the reset key, click Reset, and after completion power-cycle Epson L485.
Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Most Epson L485 waste counter resets finish in ~1–2 minutes.

FAQ

Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
How long does it take?
Usually about 1–2 minutes.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.

Guide prepared for Epson L485 – Waste Ink Counter Reset using Wic Reset Connect.

Shopping Cart