Epson ET-M1120 Waste Ink Counter Reset

Epson ET-M1120 Waste Ink Counter Reset

If your Epson ET-M1120 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.

The Epson ET-M1120 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why the Epson ET-M1120 Stops Printing (Waste Counter Limit)

Most Epson ET-M1120 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Common Symptoms

  • Printer refuses to print even with ink available
  • Epson Status Monitor shows maintenance warning
  • Blinking lights and blocked jobs
  • Device is locked until reset is performed

Step-by-Step: Epson ET-M1120 Waste Counter Reset

  1. Step 1: Connect Epson ET-M1120 to a Windows computer with a stable Internet connection using a USB cable.
  2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson ET-M1120 is detected.
  3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson ET-M1120 to finalize.
Buy Reset Key ⬇️ Download Wic Reset Connect Petunjuk

Most Epson ET-M1120 waste counter resets finish in ~1–2 minutes.

System Requirements

  • USB connection required (Wi-Fi reset not supported)
  • Valid Wic Reset Connect reset key
  • Stable Internet connection during reset
  • Windows 7/8/10/11 PC

Troubleshooting

  • Close Epson Status Monitor or other printer utilities.
  • Use a direct USB connection (avoid hubs).
  • Temporarily disable VPN/proxy if validation fails.
  • Try another USB cable (some cables are charge-only).
  • Run the app as Administrator.

Guide prepared for Epson ET-M1120 – Waste Ink Counter Reset using Wic Reset Connect.

Keranjang Belanja