How to Reset Epson TX123 Waste Ink Counter

Epson TX123 Waste Ink Counter Reset

If your Epson TX123 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson TX123 uses a software counter to estimate pad saturation and locks printing at a set threshold.

What Causes the Epson TX123 Ink Pad Counter Warning?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson TX123 waste counter reset in minutes.

Three Steps to Restore Epson TX123 Printing

  1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson TX123 via USB (Wi-Fi reset is not supported).
  2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson TX123 appears in the device list.
  3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson TX123.
Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Most Epson TX123 waste counter resets finish in ~1–2 minutes.

Before You Begin

  • Stable Internet connection during reset
  • Valid Wic Reset Connect reset key
  • Windows 7/8/10/11 PC
  • USB connection required (Wi-Fi reset not supported)

Common Fixes

  • Temporarily disable VPN/proxy if validation fails.
  • Run the app as Administrator.
  • Restart printer and PC, then try again.
  • Use a direct USB connection (avoid hubs).
  • Close Epson Status Monitor or other printer utilities.

FAQ

Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
How long does it take?
Usually about 1–2 minutes.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.

Guide prepared for Epson TX123 – Waste Ink Counter Reset using Wic Reset Connect.

Shopping Cart