Epson ET-2800 Ink Pad Counter Reset Guide

Epson ET-2800 Waste Ink Counter Reset

When the Epson ET-2800 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson ET-2800 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

What Causes the Epson ET-2800 Ink Pad Counter Warning?

Most Epson ET-2800 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

How the Error Appears

  • Printer refuses to print even with ink available
  • Epson Status Monitor shows maintenance warning
  • Blinking lights and blocked jobs
  • Device is locked until reset is performed

Three Steps to Restore Epson ET-2800 Printing

  1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson ET-2800 via USB (Wi-Fi reset is not supported).
  2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson ET-2800 is detected.
  3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson ET-2800.
Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Most Epson ET-2800 waste counter resets finish in ~1–2 minutes.

Before You Begin

  • Stable Internet connection during reset
  • Valid Wic Reset Connect reset key
  • Windows 7/8/10/11 PC
  • USB connection required (Wi-Fi reset not supported)

FAQ

What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
How long does it take?
Usually about 1–2 minutes.

Guide prepared for Epson ET-2800 – Waste Ink Counter Reset using Wic Reset Connect.

Shopping Cart