Fix Epson XP-2100 Service Required – Waste Counter Reset

Epson XP-2100 Waste Ink Counter Reset

When the Epson XP-2100 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

The Epson XP-2100 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

What Causes the Epson XP-2100 Ink Pad Counter Warning?

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson XP-2100 waste counter reset in minutes.

Common Symptoms

  • Printer refuses to print even with ink available
  • Epson Status Monitor shows maintenance warning
  • Blinking lights and blocked jobs
  • Device is locked until reset is performed

Epson XP-2100 Ink Pad Counter Reset – Quick Steps

  1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson XP-2100 via USB (Wi-Fi reset is not supported).
  2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson XP-2100.
  3. Step 3: Paste the reset key, click Reset, and after completion power-cycle Epson XP-2100.
Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Most Epson XP-2100 waste counter resets finish in ~1–2 minutes.

Troubleshooting

  • Run the app as Administrator.
  • Temporarily disable VPN/proxy if validation fails.
  • Restart printer and PC, then try again.
  • Try another USB cable (some cables are charge-only).
  • Use a direct USB connection (avoid hubs).

Frequently Asked Questions

Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
How long does it take?
Usually about 1–2 minutes.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.

Guide prepared for Epson XP-2100 – Waste Ink Counter Reset using Wic Reset Connect.

Shopping Cart