Epson ET-2723 Waste Ink Counter Reset

Epson ET-2723 Waste Ink Counter Reset

If your Epson ET-2723 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.

The Epson ET-2723 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Understanding the Epson ET-2723 Waste Ink Counter

Most Epson ET-2723 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Reset Epson ET-2723 Waste Ink Counter in 3 Steps

  1. Step 1: Connect Epson ET-2723 to a Windows computer with a stable Internet connection using a USB cable.
  2. Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson ET-2723.
  3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson ET-2723 to finalize.
Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Most Epson ET-2723 waste counter resets finish in ~1–2 minutes.

System Requirements

  • Windows 7/8/10/11 PC
  • Stable Internet connection during reset
  • Valid Wic Reset Connect reset key
  • USB connection required (Wi-Fi reset not supported)

If the Printer Is Not Detected

  • Temporarily disable VPN/proxy if validation fails.
  • Close Epson Status Monitor or other printer utilities.
  • Try another USB cable (some cables are charge-only).
  • Restart printer and PC, then try again.
  • Run the app as Administrator.

FAQ

What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
How long does it take?
Usually about 1–2 minutes.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.

Guide prepared for Epson ET-2723 – Waste Ink Counter Reset using Wic Reset Connect.

Shopping Cart