Epson XP-420 Waste Ink Counter Reset

Epson XP-420 Waste Ink Counter Reset

The Epson XP-420 is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson XP-420 uses a software counter to estimate pad saturation and locks printing at a set threshold.

What Causes the Epson XP-420 Ink Pad Counter Warning?

Most Epson XP-420 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Typical Signs

  • Printer refuses to print even with ink available
  • Epson Status Monitor shows maintenance warning
  • Blinking lights and blocked jobs
  • Device is locked until reset is performed

Epson XP-420 Ink Pad Counter Reset – Quick Steps

  1. Trin 1: Use a Windows PC (7–11) with Internet access. Connect Epson XP-420 via USB (Wi-Fi reset is not supported).
  2. Trin 2: Run Wic Reset Connect as Administrator and confirm Epson XP-420 is detected.
  3. Trin 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson XP-420.
Buy Reset Key ⬇️ Download Wic Reset Connect Instruktioner

Most Epson XP-420 waste counter resets finish in ~1–2 minutes.

Common Fixes

  • Use a direct USB connection (avoid hubs).
  • Try another USB cable (some cables are charge-only).
  • Close Epson Status Monitor or other printer utilities.
  • Temporarily disable VPN/proxy if validation fails.
  • Run the app as Administrator.

FAQ

How long does it take?
Usually about 1–2 minutes.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.

Guide prepared for Epson XP-420 – Waste Ink Counter Reset using Wic Reset Connect.

Indkøbskurv