Epson XP-33 Waste Ink Counter Reset

When the Epson XP-33 reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson XP-33 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why Does the Epson XP-33 Show ‘Service Required’?

Most Epson XP-33 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

How the Error Appears

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Three Steps to Restore Epson XP-33 Printing

1. Trin 1: Prepare a Windows PC + USB cable and connect Epson XP-33 directly. Keep Internet enabled for validation.
2. Trin 2: Run Wic Reset Connect as Administrator and confirm Epson XP-33 is detected.
3. Trin 3: Use the key to reset the counter, wait for completion, then restart Epson XP-33 to finalize.

Most Epson XP-33 waste counter resets finish in ~1–2 minutes.

Before You Begin

• Windows 7/8/10/11 PC
• USB connection required (Wi-Fi reset not supported)
• Valid Wic Reset Connect reset key
• Stable Internet connection during reset

Common Fixes

• Run the app as Administrator.
• Restart printer and PC, then try again.
• Close Epson Status Monitor or other printer utilities.
• Use a direct USB connection (avoid hubs).
• Temporarily disable VPN/proxy if validation fails.

FAQ