Epson R3000 Waste Ink Counter Reset

Epson R3000 Waste Ink Counter Reset

The Epson R3000 is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson R3000 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Understanding the Epson R3000 Waste Ink Counter

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson R3000 waste counter reset in minutes.

Common Symptoms

  • Printer refuses to print even with ink available
  • Epson Status Monitor shows maintenance warning
  • Blinking lights and blocked jobs
  • Device is locked until reset is performed

Epson R3000 Ink Pad Counter Reset – Quick Steps

  1. Trin 1: Connect Epson R3000 to a Windows computer with a stable Internet connection using a USB cable.
  2. Trin 2: Run Wic Reset Connect as Administrator and confirm Epson R3000 is detected.
  3. Trin 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson R3000.
Buy Reset Key ⬇️ Download Wic Reset Connect Instruktioner

Most Epson R3000 waste counter resets finish in ~1–2 minutes.

What You Need

  • Windows 7/8/10/11 PC
  • Valid Wic Reset Connect reset key
  • USB connection required (Wi-Fi reset not supported)
  • Stable Internet connection during reset

FAQ

Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
How long does it take?
Usually about 1–2 minutes.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.

Guide prepared for Epson R3000 – Waste Ink Counter Reset using Wic Reset Connect.

Indkøbskurv