Epson NX210 Waste Ink Counter Reset

The Epson NX210 delivers reliable printing, but periodic maintenance routines can increase the waste ink counter and eventually trigger a ‘Service Required’ lock.

The Epson NX210 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why the Epson NX210 Stops Printing (Waste Counter Limit)

With Wic Reset Connect, you can reset the Epson NX210 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Common Symptoms

• ‘Service Required’ / service life message in driver or utility
• Maintenance/support code (varies by model/driver)
• Printing stops after cleaning cycles
• Warning repeats after restarting the printer

Step-by-Step: Epson NX210 Waste Counter Reset

1. Trin 1: Prepare a Windows PC + USB cable and connect Epson NX210 directly. Keep Internet enabled for validation.
2. Trin 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson NX210.
3. Trin 3: Paste the reset key, click Reset, and after completion power-cycle Epson NX210.

Most Epson NX210 waste counter resets finish in ~1–2 minutes.

Before You Begin

• Valid Wic Reset Connect reset key
• Windows 7/8/10/11 PC
• Stable Internet connection during reset
• USB connection required (Wi-Fi reset not supported)

If the Printer Is Not Detected

• Restart printer and PC, then try again.
• Try another USB cable (some cables are charge-only).
• Run the app as Administrator.
• Use a direct USB connection (avoid hubs).
• Close Epson Status Monitor or other printer utilities.

FAQ