Canon MB2360 Printer Ink Absorber Full – How to Reset

Canon MB2360 Ink Absorber Full Reset

Canon MB2360 can lock printing when the waste ink (ink absorber) counter hits a predefined threshold. This guide explains how to reset it.

Ink absorber pads store waste ink during normal operation. Canon firmware tracks this using a software counter and may stop printing when it reaches the limit.

This page is prepared for Canon MB2360. Service mode instructions are shown only when a matching series procedure is known.

Common Symptoms

Service / maintenance warning on the screen or driver
Printer refuses to print even with ink available
Blinking lights and queued jobs fail
Error reappears after restart

Reset the Ink Absorber Counter

After service mode is enabled (if required), the waste ink counter can be reset using a supported reset procedure/software.

Before You Continue

Resetting the counter does not physically clean the absorber pads. For heavy usage, pads may eventually need cleaning or replacement.

Reset tools and instructions

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

For best results, avoid rushing button presses—consistent timing matters.

Frequently Asked Questions

Does reset clean the absorber pads?

No. It resets the counter (software). Pads may still require physical maintenance in high-usage cases.

How long does it take?

Usually a few minutes once the correct steps are followed.

Does every Canon model need service mode?

No. The generator shows service mode steps only when the series procedure is known.

How many times should I press Stop/Reset?

It depends on the series. Many use 5 presses; PRO/imagePROGRAF/MG use 6 in this generator.

Guide prepared for Canon MB2360 – Ink Absorber / Waste Ink Counter Reset using Wic Reset Connect.