Fix Epson TX830FWD WorkForce 30 Service Required – Waste Counter Reset

Epson TX830FWD WorkForce 30 Waste Ink Counter Reset

If your Epson TX830FWD WorkForce 30 suddenly refuses to print and shows a maintenance warning, it is often caused by the waste ink (ink pad) counter threshold.

The Epson TX830FWD WorkForce 30 tracks waste ink with an internal counter. Because it is an estimate (not a physical sensor), it may trigger before the pads are actually full.

Why Does the Epson TX830FWD WorkForce 30 Show ‘Service Required’?

Most Epson TX830FWD WorkForce 30 waste ink counter locks are solved by a software counter reset. Wic Reset Connect provides a straightforward procedure.

Step-by-Step: Epson TX830FWD WorkForce 30 Waste Counter Reset

  1. Step 1: Prepare a Windows PC + USB cable and connect Epson TX830FWD WorkForce 30 directly. Keep Internet enabled for validation.
  2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson TX830FWD WorkForce 30 is detected.
  3. Step 3: Paste the reset key, click Reset, and after completion power-cycle Epson TX830FWD WorkForce 30.
Buy Reset Key ⬇️ Download Wic Reset Connect التعليمات

Most Epson TX830FWD WorkForce 30 waste counter resets finish in ~1–2 minutes.

If the Printer Is Not Detected

  • Use a direct USB connection (avoid hubs).
  • Close Epson Status Monitor or other printer utilities.
  • Try another USB cable (some cables are charge-only).
  • Run the app as Administrator.
  • Temporarily disable VPN/proxy if validation fails.

FAQ

How long does it take?
Usually about 1–2 minutes.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.
Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.

Guide prepared for Epson TX830FWD WorkForce 30 – Waste Ink Counter Reset using Wic Reset Connect.

عربة التسوق