Epson TX810FW Waste Ink Counter Reset

When the Epson TX810FW reaches its maintenance threshold, Epson firmware may block printing as a safeguard. In most cases, this is resolved with a counter reset.

A waste ink counter in the Epson TX810FW accumulates after cleaning operations. Once it reaches a limit, printing is stopped to prevent overflow.

Understanding the Epson TX810FW Waste Ink Counter

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson TX810FW waste counter reset in minutes.

Typical Signs

• Printer refuses to print even with ink available
• Epson Status Monitor shows maintenance warning
• Blinking lights and blocked jobs
• Device is locked until reset is performed

Reset Epson TX810FW Waste Ink Counter in 3 Steps

1. Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson TX810FW via USB (Wi-Fi reset is not supported).
2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson TX810FW is detected.
3. Step 3: Paste the reset key, click Reset, and after completion power-cycle Epson TX810FW.

Most Epson TX810FW waste counter resets finish in ~1–2 minutes.

What You Need

• Valid Wic Reset Connect reset key
• Stable Internet connection during reset
• Windows 7/8/10/11 PC
• USB connection required (Wi-Fi reset not supported)

Common Fixes

• Try another USB cable (some cables are charge-only).
• Close Epson Status Monitor or other printer utilities.
• Run the app as Administrator.
• Temporarily disable VPN/proxy if validation fails.
• Use a direct USB connection (avoid hubs).

FAQ