Epson TX560WD Ink Pad Counter Reset Guide

Epson TX560WD Waste Ink Counter Reset

The Epson TX560WD delivers reliable printing, but periodic maintenance routines can increase the waste ink counter and eventually trigger a ‘Service Required’ lock.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson TX560WD uses a software counter to estimate pad saturation and locks printing at a set threshold.

Understanding the Epson TX560WD Waste Ink Counter

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson TX560WD waste counter reset in minutes.

Typical Signs

  • ‘Service Required’ / service life message in driver or utility
  • Maintenance/support code (varies by model/driver)
  • Printing stops after cleaning cycles
  • Warning repeats after restarting the printer

Three Steps to Restore Epson TX560WD Printing

  1. Step 1: Connect Epson TX560WD to a Windows computer with a stable Internet connection using a USB cable.
  2. Step 2: Run Wic Reset Connect as Administrator and confirm Epson TX560WD is detected.
  3. Step 3: Use the key to reset the counter, wait for completion, then restart Epson TX560WD to finalize.
Buy Reset Key ⬇️ Download Wic Reset Connect التعليمات

Most Epson TX560WD waste counter resets finish in ~1–2 minutes.

Troubleshooting

  • Try another USB cable (some cables are charge-only).
  • Run the app as Administrator.
  • Use a direct USB connection (avoid hubs).
  • Close Epson Status Monitor or other printer utilities.
  • Restart printer and PC, then try again.

FAQ

Can I reset over Wi-Fi?
No. The reset requires a USB connection to a Windows PC.
How long does it take?
Usually about 1–2 minutes.
Do I need a service center?
Typically not for a waste ink counter lock; a reset is usually sufficient.
What if reset doesn’t work?
Check USB cable/port, run as admin, and close other printer utilities.

Guide prepared for Epson TX560WD – Waste Ink Counter Reset using Wic Reset Connect.

عربة التسوق