Epson ET-2756 Waste Ink Counter Reset

The Epson ET-2756 delivers reliable printing, but periodic maintenance routines can increase the waste ink counter and eventually trigger a ‘Service Required’ lock.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson ET-2756 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why the Epson ET-2756 Stops Printing (Waste Counter Limit)

A service visit is often unnecessary. Wic Reset Connect allows a safe Epson ET-2756 waste counter reset in minutes.

Common Symptoms

• Printer refuses to print even with ink available
• Epson Status Monitor shows maintenance warning
• Blinking lights and blocked jobs
• Device is locked until reset is performed

Epson ET-2756 Ink Pad Counter Reset – Quick Steps

1. Step 1: Prepare a Windows PC + USB cable and connect Epson ET-2756 directly. Keep Internet enabled for validation.
2. Step 2: Start Wic Reset Connect in Administrator mode and wait until Epson ET-2756 appears in the device list.
3. Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson ET-2756.

Most Epson ET-2756 waste counter resets finish in ~1–2 minutes.

System Requirements

• Stable Internet connection during reset
• USB connection required (Wi-Fi reset not supported)
• Windows 7/8/10/11 PC
• Valid Wic Reset Connect reset key

If the Printer Is Not Detected

• Run the app as Administrator.
• Restart printer and PC, then try again.
• Temporarily disable VPN/proxy if validation fails.
• Try another USB cable (some cables are charge-only).
• Use a direct USB connection (avoid hubs).

FAQ