Reset Epson XP-446 Waste Ink Counter in Minutes

Epson XP-446 Waste Ink Counter Reset

The Epson XP-446 is a widely used Epson printer. Like many Epson devices, it can stop printing when the internal waste ink counter reaches its predefined limit.

During head cleaning and maintenance cycles, excess ink is routed to internal absorber pads. The Epson XP-446 uses a software counter to estimate pad saturation and locks printing at a set threshold.

Why the Epson XP-446 Stops Printing (Waste Counter Limit)

With Wic Reset Connect, you can reset the Epson XP-446 waste ink counter quickly using a Windows PC, USB connection, and a valid reset key.

Typical Signs

‘Service Required’ / service life message in driver or utility
Maintenance/support code (varies by model/driver)
Printing stops after cleaning cycles
Warning repeats after restarting the printer

Step-by-Step: Epson XP-446 Waste Counter Reset

Step 1: Use a Windows PC (7–11) with Internet access. Connect Epson XP-446 via USB (Wi-Fi reset is not supported).
Step 2: Open Wic Reset Connect with admin privileges and verify device recognition for Epson XP-446.
Step 3: Enter your reset key and press Reset. Wait ~1–2 minutes, then restart Epson XP-446.

Buy Reset Key ⬇️ Download Wic Reset Connect Instructions

Most Epson XP-446 waste counter resets finish in ~1–2 minutes.

Common Fixes

Use a direct USB connection (avoid hubs).
Temporarily disable VPN/proxy if validation fails.
Run the app as Administrator.
Restart printer and PC, then try again.
Try another USB cable (some cables are charge-only).

FAQ

What if reset doesn’t work?

Check USB cable/port, run as admin, and close other printer utilities.

Do I need a service center?

Typically not for a waste ink counter lock; a reset is usually sufficient.

How long does it take?

Usually about 1–2 minutes.

Can I reset over Wi-Fi?

No. The reset requires a USB connection to a Windows PC.

Guide prepared for Epson XP-446 – Waste Ink Counter Reset using Wic Reset Connect.